Line: 1 to 1 | ||||||||
---|---|---|---|---|---|---|---|---|
What is IoT? | ||||||||
Line: 26 to 26 | ||||||||
Then the video demonstration how a Python program on the IoT node can communicate through MQTT with the mosquitto server. The python program publishes dummy temperature data. | ||||||||
Changed: | ||||||||
< < | https://afnog.iotworkshop.africa/pub/AFNOG/Talk/mosquitto-1.mp4 | |||||||
> > | https://afnog.iotworkshop.africa/pub/AFNOG/Talk/mosquittoDummyData.mp4 | |||||||
The next video does not access MQTT but demonstrates how to switch an LED on a WeMos D1 prototype shield on and of. It also reads out a photo resistor and shows the change in resistance when the intensity impinging on it changes. | ||||||||
Changed: | ||||||||
< < | %ATTACHURL/%/protoDriver.mp4 | |||||||
> > | https://afnog.iotworkshop.africa/pub/AFNOG/Talk/protoDriver.mp4 | |||||||
Finally a video to demonstrate the full IoT system. You can switch the LED on the prototype board on or off with a Cayenne push button. This will change the light intensity on the photo resistor, which is shown on a gauge widget on Cayenne. If the light intensity falls below a predefined level a Cayenne trigger will switch built-in LED on the WeMos CPU on. If it goes back above that level, the built-in LED is automatically switched off again. | ||||||||
Changed: | ||||||||
< < | %ATTACHURL/%/cayenneProto.mp4 | |||||||
> > | https://afnog.iotworkshop.africa/pub/AFNOG/Talk/cayenneProto.mp4 | |||||||
-- Uli Raich - 2019-04-28 | ||||||||
Line: 42 to 42 | ||||||||
Changed: | ||||||||
< < |
| |||||||
> > |
| |||||||
| ||||||||
Deleted: | ||||||||
< < |
| |||||||
| ||||||||
Added: | ||||||||
> > |
|